Resetting And Clearing The Server; Software Reset; Forced Shutdown; Resetting Ilo - NEC N8100-2834F Maintenance Manual

Chapter 1 Maintenance
7.

Resetting and Clearing the Server

See this section if the server does not work or if you want to set the system settings back to the default settings.
7.1

Software Reset

In case POST processing stops and does not operate, or the server stops during the start-up of System Utility,
press <Delete> key while pressing <Ctrl> key and <Alt> key. Clear all the data in progress that are stored in
the memory and restart.
7.2

Forced Shutdown

In case you cannot turn off the power in the following situations, press the power switch of device for 4 seconds
or longer. You can forcefully turn off the power.
・Unable to turn off the power although you have executed the shutdown from OS.
・Unable to turn off the power although you have pressed the POWER switch.
Regarding the position of POWER switch, see Chapter 1 (4.2 Front View (Without Front Bezel)) in User's Guide.
7.3

Resetting iLO

You can manually start a reset of iLO by using the UID switch on the front.
・When you press and hold the UID switch for 5 to 9 seconds, a safe restart of iLO starts.
・When you press and hold the UID switch for 10 seconds or longer, a hardware restart of iLO starts.
For details, refer to iLO 5 User's Guide.
68
Note
If you want to turn on the power again, do so after you wait for 30 seconds or
longer.
Important Do not restart iLO during the time from when the server starts up until the
OS startup is completed (including the execution of POST (Power On Self
Test)). Also, do not restart iLO during System Utilities operations.
Express5800/R120h-1M, R120h-2M (3rd-Gen) Maintenance Guide
7. Resetting and Clearing the Server