Table 2-74 Cpu Reset Programs - NEC Univerge SV8100 Features And Specifications Manual

UNIVERGE SV8100
When installing a Secondary System in a Netlink network and the Secondary System has

CD-LCA blades installed, the CD-LCA blades will come online and assign ports before any
CD-DLCA blades are assigned.
Always connect to the Primary System when using PCPro.

When using K-CCIS – T1 in a Netlink system, the CCTA blade is only supported in the

primary system.
The following programs require a reset after making a change using PCPro, WebPro or

Handset programming:
With Version 4000 software, the failover process in a Netlink environment is improved.

When network communication is down, an alarm is sent to the Attendant terminal informing
of the communication error on the network. Improvements also allow for a defined number
of network outages per clock hour before failing over.
With Version 4000 or higher software, DT700 series IP terminals and wireless IP

terminals can be registered to secondary systems in a NetLink environment, Softphones
must still register to the primary only.
When the Attendant telephone exists on a secondary system, alarm information is not

displayed on the Attendant telephone.
When Fail Over occurs between the Primary System and two or more Secondary Systems,

the Attendant telephone displays the System ID of the system that went into Fail-Over last.
When using InMail in a CCIS or Netlink network, 8-digit extensions and mailboxes are not

supported.
SV8100 NetLink

Table 2-74 CPU Reset Programs

Program
10-12-01 Handset, WebPro, PCPro
10-12-02 Handset, WebPro, PCPro
10-12-09 Handset, WebPro, PCPro
51-01-01 Handset, WebPro, PCPro
51-15 WebPro, Handset Programming
84-03-06 Handset, WebPro, PCPro
90-04 Handset Programming
90-58 Handset Programming
10-46-07 PcPro
84-23 Handset, WebPro, PCPro
When Changed Using
Issue 8.01
2 - 1357