Fitting The Scanner Drive Cable; Adjusting The Position Of The No. 1/No. 2 Mirror Base - Canon imageRUNNER 5065 series Service Manual

frame.
19) Detach the cable for the pulleys.
[2]
[3]

5.4.13.4 Fitting the Scanner Drive Cable

iR5065 / iR 5055 / iR5075 / / /
1) Put the ball of the cable into the hole of the drive pulley [1], and wind the
cable (4 times inside; 5 times outside); then, tape it in place. At this time,
make sure that the cable fixing [2] is on the inside.
2) Fit the cable on the pulleys; then, fit one end on the left side hook [3] and
the other end on the right side hook [4].
3) Temporarily fix the cable fixing plate [2] in place on the No. 1 mirror base
[5].
4) Mount the reader unit upper frame.
[2]
[3] [3]
[1]
[4]
[4]
[2]
F-5-100
[1]
[1]
[4] [5]
[4]
[2]
F-5-101
5.4.13.5 Adjusting the Position of the No. 1/No. 2 Mirror
Base
iR5065 / iR 5055 / iR5075 / / /
0015-4860
1) Arrange the mirror positioning tool (FY9-3009-040) so that it is ready for
use in the machine (by changing the pin position; REAR).
2) Arrange the mirror positioning tool so that it is ready for use in the
machine (by changing the pin position; FRONT).
Chapter 5
[4] [5]
[4]
F-5-102
[C]
[B]
[A]
[A]
[B]
F-5-103
0015-9945
5-27