Trunk Group Outgoing Priority Selection - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
5-06 Trunk Group Outgoing Priority
Selection
General Description
Use this Memory Block to assign the Outgoing Priority for trunk access to each Trunk
Group. This is normally used with a Tie Line or K-CCIS network to reverse the search
order and reduce call collisions during trunk seizure.
Display
T r u n k
G r o u p
D a t a
( 0 1 ~ 3 2 )
N o .
0 1 / 0 6 : P R I O R .
T I M E
Settings
LK 1 LK 2
H → L L → H
High to Low Low to High
Programming Procedures
G
1 Go off-line.
2 Press LK5 + +
G
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-1-46~48 Access Code (1-, 2- or 3-Digit) Assignment
Function 201~232 – Route Advance Block 01~32
Function 401~416 – Closed Number Block 01~32
Function 601~604 – ARS Table 1~4
1-1-30
Route Advance Block Assignment
1-1-49
Networking Trunk Group/Route Advance Assignment
1-14-04 ARS Trunk Group to Route Number Assignment
This Memory Block should not be assigned (use default) for trunk groups with trunks belonging to an IAD(8)-U( )
ETU used with IP (K-CCIS) or IP (K-CCIS) to NEAX (Point-to-Multipoint).
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e
D a t a
H > L
D I S P L A Y
LK 3 LK 4 LK 5
K F
t o access the Memory Block.
E
to go back on-line.
LK 6 LK 7
Notes
Document Revision 4
Trunk Group Mode
5
Submode
Data No.
06
PC Programming
+ALN
LK 8
The shaded
selection is the
default.
2 - 617