Trunk Queuing - Outgoing - NEC UNIVERGE SV9300 DT410 User Manual

TRUNK QUEUING -
OUTGOING
This feature allows a terminal user, upon
encountering a busy signal on a trunk, to set a call
and enter a first-in, first-out queue. As soon as an
outgoing trunk becomes available, terminals in the
queue will be called back on a first-in, first-out
basis.
This feature is set by Soft key or feature key.
The feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
TO SET TRUNK QUEUING –
OUTGOING
This feature is available only for the terminal
that is set by system data setting at initial
installation.
1. Press Speaker key and dial the
outgoing access code.
Speaker key lamp lights red. →
Line key lamp lights red. →
The lines are all busy status.
You will receive a busy tone.
BUSY
11:00 AM SUN 1 JUN 2014
CB
2. Press Soft key (CB) or Trunk
Queuing - Outgoing feature key.
You will receive a service set tone.
Outgoing feature key lamp lights red. →
3. Press Speaker key.
Speaker key lamp goes off. →
Wait until the outgoing line is available.
SET
11:00 AM SUN 1 JUN 2014
26-255XX
26-255XX
45
WHEN TRUNK IS AVAILABLE
1. Ringing of external incoming call is
heard.
Call Indicator Lamp flashes red.
Line key lamp flashes red. →
CALL BACK
11:00 AM SUN 1 JUN 2014
Recall PICK
2. Lift the handset or press Speaker
key.
Outgoing feature key lamp goes off. →
Call Indicator Lamp goes off.
Line key lamp lights green. →
3. Dial the desired number.
11:00 AM SUN 1 JUN 2014
Recall VOICE
TO CANCEL
This feature is available only for the terminal
that is set by system data setting at initial
installation.
1. Lift the handset.
Line key lamp lights red. →
11:00 AM SUN 1 JUN 2014
Recall PICK
FEATURE OPERATION
26-255XX
>>>>
81XXXXXXXXXX
CB >>>>
200
>>>>