Diagnostic Information And Procedures (A/T); A/T System Check; Visual Inspection - Suzuki Liana RH418 Supplementary Service Manual

A/T System Check

Refer to the following items for the details of each step.
Step
1 Customer complaint analysis
1) Perform customer complaint analysis.
Was customer complaint analysis performed?
2 DTC check, record and clearance
1) Check for DTC referring to "DTC Check".
Is there any DTC(s)?
3

Visual inspection

1) Perform visual inspection.
Is there any faulty condition?
4 Visual inspection
1) Perform visual inspection.
Is there any faulty condition?
5 Trouble symptom confirmation
1) Perform confirm trouble symptom.
Is trouble symptom identified?
6 Rechecking and record of DTC
1) Recheck for DTC referring to "DTC Check".
Is there any DTC(s)?
7 Rechecking and record of DTC
1) Recheck for DTC referring to "DTC Check".
Is there any DTC(s)?
8 A/T basic check and A/T symptom diagnosis
1) Check and repair according to "A/T Basic Check" and "A/
T Symptom Diagnosis".
Are check and repair complete?
9 Troubleshooting for DTC
1) Check and repair according to applicable DTC flow.
Are check and repair complete?
10 Check for intermittent problems
1) Check for intermittent problem.
Is there any faulty condition?
11 Final confirmation test
1) Clear DTC if any.
2) Perform final confirmation test.
Is there any problem symptom, DTC or abnormal condition?
Diagnostic Information and Procedures
Action
Automatic Transmission/Transaxle:
Yes
Go to Step 2.
Print DTC or write it
down and clear them by
referring to "DTC
Clearance". Then go to
Step 3.
Repair or replace
malfunction part. Then
go to Step 11.
Repair or replace
malfunction part. Then
go to Step 11.
Go to Step 6.
Go to Step 9.
Go to Step 9.
Go to Step 11.
Go to Step 11.
Repair or replace
malfunction part(s).
Then go to Step 11.
Go to Step 6.
5A-11
S3RH0B5104001
No
Perform customer
complaint analysis.
Go to Step 4.
Go to Step 5.
Go to Step 8.
Go to Step 7.
Go to Step 8.
Go to Step 10.
Check and repair
malfunction part(s).
Then go to Step 11.
Check and repair
malfunction part(s).
Then go to Step 11.
Go to Step 11.
End.