RESOLVING PROBLEMS
System Fails
Rapid Power-On
Tests
If you have this symptom...
An error message occurs during
the power on procedures.
8-4
Venue•2000 performs several tests when you power up the system.
These tests, called Rapid Power-On Tests (RPOT), check the
hardware components and system software. If the tests are
successful,
PictureTel Ready
The following table summarizes the corrective actions you can
follow if your system fails the RPOT.
1. Make sure that all cable connections to the
electronics module are correct and secure.
2. Press ENTER to run more tests.
3. If the test results indicate a video, audio, or network
problem, refer to the checklists in this chapter to
attempt to isolate the problem.
If you canÕt resolve the problem or the tests
indicate a defective component, contact your
PictureTel service provider.
If the tests indicate a problem with the network,
contact your network provider.
appears.
Do this...