PictureTel Venue-2000 Administrator's Manual page 156

CONFIGURING DATA PORTS
Setting
(continued)
Protocol
Data Rate
Data Bits
Stop Bits
Parity
Flow Control
6-6
Ñ ConÞgures the port to communicate with devices
Transparent data
that are unfamiliar to Venue•2000. In this case, the
videoconferencing system acts like a modem. You must set the other
conÞguration choices on the Data Port ConÞguration menu.
Ñ ConÞgures the data port for use with the DeveloperÕs ToolKit
DTK
(DTK) for customizing purposes. All other conÞguration choices on
the Data Port ConÞguration menu are automatically set for you. See
the DTK documentation for more information.
PictureTel Remote
Remoteª for diagnostic purposes. All other conÞguration choices
on the Data Port ConÞguration menu are automatically set for you.
See the PictureTel Remote documentation for more information.
Other Peripherals
compliant peripheral device whose type is other than those listed
above. All other conÞguration choices on the Data Port
ConÞguration menu are automatically set for you.
Choices are ,
300 1200
default setting.) The corresponding data port on the far-end system
must be conÞgured at the same data rate setting.
Choices are or . (
7 8 8
on the far-end system must be conÞgured at the same data bits setting.
Choices are or . (1 is the default setting.) The corresponding data port
1 2
on the far-end system must be conÞgured at the same stop bits setting.
Choices are ,
None Odd
port on the far-end system must be conÞgured at the same parity setting.
Choices are:
Ñ Flow control is implemented by the hardware using the
CTS/RTS
CTS and RTS pins, not the software. (Default setting.)
Ñ Used when this method is required by the terminal
XON/XOFF
device to stop and start the ßow of data.
Choices
Ñ ConÞgures the data port for use with PictureTel
Ñ ConÞgures the data port for use with a T.120-
, , , ,
2400 4800 9600 19200
is the default setting.) The corresponding data port
, or . ( is the default setting.) The data
Even None
, or . ( is the
38400 38400