Table of Contents
Advertisement
RESOLVING PROBLEMS
If you have these symptoms...
The message
Network Disconnected
appears during the power-on
process or during operation.
(continued)
You can make outgoing calls
greater than 128 kbps, but canÕt
receive incoming calls greater than
128 kbps.
8-14
And this
network...
ISDN Triple-
4. Run the Network Reflector
BRI
ISDN Triple-
1. Check to see if the site that is
BRI
Do this...
Loopback test from the Loopback
Tests menu to determine if the
problem is with the network
interface board or the network
itself. Contact your network
provider to get a loopback number
you can call.
If this test indicates a defective
network interface board, call
your PictureTel service provider.
(See ÒRunning the Network
Reßector Loopback TestÓ on
page 7-17 for information on
how to interpret results of this
test.)
If the test indicates a problem
with the network, contact your
network provider.
attempting to call you is using the
BONDING protocol for inverse
multiplexing.
All calls placed using inverse
multiplexing must use the
BONDING protocol; other
proprietary inverse multiplexing
protocols are not supported.
The ISDN Triple-BRI network
interface does not support H0
(Hyperchannel zero, or SW384)
calls from an ISDN PRI (Primary
Rate Interface) network.
Advertisement
Table of Contents
