Table of Contents
Advertisement
Connecting the Power Supply
Connecting to
the Network
From the Live100 Audio Communcations Board
From a Network Interface board
If you plan to use the speakerphone in a large room or if your PC is
not providing sufficient power for quality audio, you may choose to
use the optional power supply.
To connect the optional power supply, follow these steps:
1. Plug the power supply cable into the power socket labeled
on the back of the speakerphone unit.
2. Plug one end of the power cord into the power supply.
3. Plug the other end of the power cord into a wall outlet.
The Live100 connection to the network is made from a socket in the
network interface board to a network service jack. To connect your
PC to the network, follow the procedure below for the network
interface board you have previously installed.
If you are connecting directly into an ISDN BRI network, using the
Live100 audio communications board, follow these steps:
1. Plug one end of the 8-pin modular network cable into the RJ-45
socket labeled ISDN on the Audio Communications board.
2. Plug the other end of the cable into the network service jack.
If you are connecting to a network using an optional network
interface board , refer to Appendix C for specific information about
your connection.
Connecting to the Network
3-15
12V
+
Advertisement
Table of Contents
