Table of Contents
Advertisement
CONFIGURING NETWORKS
2-8
screen. If they are incorrect, you need to enter the correct
numbers.
Other dialects allow you to enter local numbers and do not
require SPIDs. You must enter the correct local numbers in the
Set Local Numbers entry screen; the system does not provide
any defaults.
For sites using the NI1 dialect, you can enter one or two
SPIDs. Sites using DMS100 always require two SPIDs.
The kind of identiÞers you use depends on what type of
equipment you are using and the country in which you are
operating.
Contact your network provider if you have any questions
about SPIDs or local numbers.
To enter SPIDs or local numbers:
1. Choose Set Number Type from the ISDN Protocol Configuration
menu.
Depending on the dialect you are using, you may be required to
enter SPIDs or local numbers or both.
2. Choose Set SPIDs or Set Local Numbers .
The Set SPIDs or Set Local Numbers entry screen appears. The
following screen is an example of the Set SPIDs entry screen:
3. Enter the appropriate numbers associated with the ISDN line.
Press ENTER after each number.
The message
Please restart system for changes to take effect
appears.
4. Restart the system for the changes to take effect.
Advertisement
Table of Contents
