Table of Contents
Advertisement
RUNNING SYSTEM TESTS
7-16
The following Þgure illustrates how the Local Channel Loopback
test runs.
Monitor
and speakers
To set a rate and run the local loopback test:
1. From the Local Channel Loopback menu, choose Set Loopback
Rate .
Specify the rate at which you want the test to run. You should
choose a rate that you typically use to make calls so that the test
emulates your videoconferencing scenario as much as possible.
2. From the Local Channel Loopback menu, choose Run Local
Channel Loopback.
3. Make sure that the image from your camera source is displayed on
the full screen and in the PIP.
4. Tap gently on the microphone or speak into it.
If you donÕt see the video image displayed or you canÕt hear
sound, continue with the next step.
5. Verify that all cable connections are correct and are securely in
place by doing the following:
Check the video cable from the electronics module to the
monitor.
Check the audio cable from the electronics module to the
monitor.
Codec
Electronics module
Network
Advertisement
Table of Contents
