3-4.
ADJUSTMENT OF BELT TENSION
Checks after Adjustment
• Turn the Timing Belt and check that all the Pulleys and grooves of the Belt fit securely.
• Each Belt should flex a little when the Belt is lightly pressed with a finger.
Reference
Since a given tension is applied by a tension spring to the Tension Lever that maintains the
tension of each timing belt, adjustment is completed by re-tightening the mounting screw
after it has been loosened.
(1)
Adjustment of the Suction Drive Timing Belt
(2)
Adjustment of the Developing Unit Drive Timing Belt
Tension Lever 2
1. Remove the Rear Cover.
2. Loosen the screw by which the Tension Lever is
mounted as shown on the left and then re-tighten
it.
4002D200AB
1. Remove the Rear Cover.
2. Remove the Master Board mounting bracket Assy.
and FlyWheel.
3. Remove five screws and the Developing Unit Drive
Assy.
4002D072AB
4. Remove two screws and the Tension Lever 2.
Tension
5. Loosen the screw by which the Tension Lever 1 is
Lever 1
mounted as shown on the left and then re-tighten
it.
6. Reinstall the Tension Lever 2.
4002D201AC
D-76