[31] Adjusting the tilt of PI (when PK
punch is used)
1.
Tool
• Screwdriver (Phillips)
• Scale
2.
Adjustment method
a.
Preparation
Step
Check the following items:
• PI is connected to FNS.
1
• The tray of PI is loaded with paper.
Check the tilt of output paper in advance.
• Feed 3 sheets from PI with the Punch
2
mode selected to check the tilt of punch
holes.
Loosen one screw securing the guide
3
plate.
b.
Adjustment
Step
Open the front door of the finisher.
Tilting toward
the right edge
of the sheet
1
Open the FNS front cover.
2
Loosen one screw securing the guide
3
plate.
Operation
Operation
Tilting toward
the left edge
of the sheet
2-138
Step
Operation
Using the mark as a guide, move the guide
plate laterally by the amount of tilt in the
position of punch holes.
4
Tilting toward
the right edge
of the sheet
Retighten the screw securing the guide
5
plate.
Repeat steps 1 to 5 until the amount of tilt
6
in the position of punch holes is improved.
ADJUSTMENT
Screw
securing
the guide
plate
Tilting toward
the left edge
of the sheet