Sending Signals From Mix Channels To The Stereo/Mono Bus - Yamaha CL1 Reference Manual

2 3
4
Follow the steps for the input channels (see
1
page 29).
Sending signals from MIX channels to the STEREO/
MONO bus
This section explains how to send a signal from a MIX channel to the STEREO bus or MONO bus.
There are two ways to send signals to the STEREO bus or MONO bus: ST/MONO mode and LCR
mode. You can select the mode individually for each channel. Features of each mode are the same as for
input channels.
1.
Use the Bank Select keys in the Centralogic section to access the OVERVIEW screen
that includes the MIX channel from which you want to send the signal to the
STEREO/MONO bus.
STEREO/MONO field
2.
In the STEREO/MONO field, press a knob to select the channel you want to adjust,
and then press the knob once again to access the TO STEREO/MONO popup
window.
In the TO STEREO/MONO popup window, you can control a signal that is sent from the MIX
channel to the STEREO/MONO bus. This popup window features four types of view. Use the tabs
near the bottom of the window to select one of the four views. These windows include the
following items.
48
Output channels
Reference Manual