Added More Parameters To Channel Strip Section (Nuage Fader); Added Support For Switching Parameters In Channel Setting Mode (Nuage Fader); Added Key Function (Shortcut) For Dividing Events Into Selected Ranges (Nuage Master) - Yamaha NUAGE MASTER Ncs500-CT Operation Manual

Added More Parameters to
Channel Strip Section
(Nuage Fader)
You can now adjust HC SLOPE, LC SLOPE, GAIN,
φ (PHASE), HA HPF, and HA +48V in the channel strip.
HA GAIN and HA GC, which were previously assigned to
[Sub parameter 2], have been moved to [Sub parameter
4].
Operation
1. Press [PRE] in the SECTION CONTROL section.
2. Press one of the parameters in [Sub parameter 2] to
[Sub parameter 5].
The parameters below are displayed in the label area.
3. Adjust the parameter using the corresponding
[Multi function knob] or [Multi function button].
Sub parameter 2
HC SLOPE, LC SLOPE
Sub parameter 3
GAIN, φ (PHASE)
Sub parameter 4
HA GAIN, HA GC
(for Rio3224-D/Rio1608-D remote control)
HA GAIN, HA TRIM
(for AD8HR remote control)
Sub parameter 5
HA HPF, HA +48V
(for HA remote control)
Added Support for Switching
Parameters in Channel Setting
Mode (Nuage Fader)
You can now switch sub-parameters in the Channel
Setting mode to make adjustments to parameters.
NOTE
Only the following two types of "Dynamics" are currently
supported:
• DeEsser (Cubase Pro 8 and later)
• Envelope Shaper
Operation
With either DeEsser or Envelope Shaper selected in
"Dynamics" in the channel displayed in Channel Setting
mode, do the following:
1. Press [DYN] in the SECTION CONTROL section.
2. Press [Sub parameter 2].
The parameter display in the label area is switched.
3. Adjust the parameter using the corresponding
[Multi function knob] or [Multi function button].
Added Key Function
(Shortcut) for Dividing Events
into Selected Ranges (Nuage
Master)
You can now use key function (shortcut) in Nuage Master
to divide events into selected ranges.
Operation
1. In the Nuendo Project window, use the range
selection tool to select the range for dividing a
track.
2. Press and hold [SHIFT] in the MODIFIER section
while holding down [SPLIT] in the JOG WHEEL
section.
The event is divided into the selected ranges.
Added functions in NUAGE V1.6 84