Encoder Mode / Fader Mode - Yamaha 02R96-v2 Quick Start Manual

ENCODER MODE / FADER MODE

The encoders above the faders can be used to edit various channel
parameters. The most useful ones are Pan and Aux send.
1. To edit Pan on the encoders, just press the PAN ENCODER
MODE switch and turn the required encoder. The LCD display will
show the pan position in a 'pop-up' window.
3
2. To edit Aux on the encoders, press the AUX ENCODER
MODE switch, then select the required AUX# (1-8) with one of the AUX
SELECT switches above. The LCD display will show the Aux level in a
'pop-up' window.
3. To see the Aux send information for many channels at the
same time, press the AUX SELECT DISPLAY switch. Each time this
switch is pressed, it will change the LCD to a different page to see the
information for other channels. In these pages Pre/Post status can be
edited, and the Aux sends can be switched off by pressing ENTER
while the cursor is high-lighting the level encoder.
4. When the AUX FADER MODE switch is pressed, the Aux
Send levels are shown on the faders instead of the channel level.
Choose which Aux to see on the faders with the AUX SELECT
switches (as in step 2 above). Press the FADER switch to resume
normal level operation on the faders.
7 02R96-v2 Quick Start Guide
2
1 2
4