Connecting And Disconnecting From A Digital Audio Device - Raritan dominion kx III Administrator's Manual

Operating System Audio Playback Support
Review the table shown here to see which Raritan client works with
audio playback/capture for each operating system:
Operating system
®
Windows
®
Linux
®
Mac

Connecting and Disconnecting from a Digital Audio Device

Audio device settings are applied on a per KX III device basis.
Once the audio devices settings are configured and saved on the KX III,
the same settings are applied to it.
See Saving Audio Settings
Note: If you are using the audio feature while running PC Share mode
and VM Share mode, see
Recommendations and Requirements
information. See also Connecting to Multiple Targets from a Single
Remote Client (on page 310).
Connect to a Digital Audio Device
To connect to an audio device:
1. Connect the audio device to the remote client PC prior to launching
the browser connection to the KX III.
2. Connect to the target from the Port Access page.
3. Once connected, click the Audio button
The Connect Audio Device dialog appears. A list of available audio
devices connected to the remote client PC is displayed.
Note: If there are no available audio devices connected to the remote
client PC, the Audio icon is grayed out. .
4. Check Connect Playback Device if you are connecting to a playback
device.
5. Select the device that you wish to connect from the drop-down list.
Chapter 7: Virtual KVM Client (VKC and VKCs) Help
Audio playback and capture supported
by:

Active KVM Client (AKC)

Virtual KVM Client (VKC)

Virtual KVM Client (VKC)

Virtual KVM Client (VKC)
(on page 310) for more information.
Audio Playback and Capture
(on page 307) for important
in the toolbar.
311