Raritan dominion kx III Administrator's Manual page 194

Chapter 4: KX III Administration
182
2. If you are plugging power input into power supply number one
(left-most power supply at the back of the unit), then select the
Powerln1 Auto Detect option.
3. If you are plugging power input into power supply number two
(right-most power supply at the back of the unit), then select the
Powerln2 Auto Detect option.
4. Click OK.
To turn off the automatic detection:

Deselect the checkbox for the appropriate power supply.
To reset to factory defaults:

Click Reset To Defaults.
Note: The KX III does NOT report power supply status to
CommandCenter. Dominion I (generation 1), however, does report
power supply status to CommandCenter.