Raritan dominion kx III Administrator's Manual page 203

2. Click Add. The Port Group page opens, and all available ports are
displayed in the Select Ports for Group section.
Note: If a port is already a part of blade server port group, another
dual video port group, or 'standard' port group, the port is not an
option since ports can only belong to a single port group at a time.
3. Select the Dual Video Port Group radio button.
4. From the Select Ports for Group section, click on the port you are
designating as the primary port, then click Add to add it to the
Selected text box. Be sure to add the primary port first.
Note: Ideally, the permissions applied to each port in the port group
should be the same. If they are not, the permissions of the port with
the most restrictive permissions is applied to the port group. For
example, if VM Access Deny is applied to one port and VM Access
Read-Write is applied to another port, VM Access Deny is applied to
the port group. See
Access (on page 243) for information on how port permissions affect
dual video port groups.
5. Click on the port that you are designating as the secondary port and
click Add to add it to the Selected text box.
6. Select the orientation of the page. The orientation you select
depends on what works best with your monitor setup.
7. Click OK to create the port group.
Dual video port groups appear on the Port Access page as Dual Port
types.
The primary and secondary ports that are a part of the port group
appear on the Port Access page as Dual Port(P) and Dual Port(S),
respectively. For example, if the CIM type is DCIM, "DCIM Dual Port
(P)" is displayed.
Note: Dual Video port targets attached to a tier device should only be
connected via the tier device, not through the tier base device.
Permissions and Dual Video Port Group
Chapter 4: KX III Administration
191