Step 4: Configuring The Kx Iii - Raritan dominion kx III Administrator's Manual

2. Plug the DVI-D to VGA converter in to the DVI-D port on the back of
the KX III, and secure it by turning the screws on each side
clockwise.
3. Connect a VGA cable to the DVI-D to VGA converter, connect the
other end to your VGA monitor and secure it by tightening the
screws.
Note: The DVI-D to VGA converter is not included with the KX III.
Contact Raritan Sales for information.
E. Connect Target Servers to KX III
1. Connect the keyboard, mouse and video plugs on the CIM to the
corresponding ports on the target server.
2. Connect the CIM to an available target server port on the back of the
KX III via a Cat5/5e/6 cable.
F. Tiering (Optional)
See Configuring and Enabling Tiering
G. Connect the Modem (Optional)
See Configuring Modem Settings

Step 4: Configuring the KX III

For the following steps, you must change the default password and
assign the KX III its IP address at the Local Console.
All other steps can be performed either from the Local Console, or the
KX III Remote Console via a supported web browser using the KX III's
default IP address.
™
Java 1.7 or 1.8 is required to use the Java-based Virtual KVM Client
(VKC). Java 1.8.0_40 is required to use the VKCS.
®
Microsoft .NET 4.0 (or later) is required to use KX III with the Microsoft
®
Windows -based Active KVM Client (AKC).
Change the Default Password
The first time you start the KX III device, you are required to change the
default password.
1. Once the unit has booted, enter the default username admin and
password raritan.
2. Click Login.
Chapter 4: KX III Administration
(on page 149)
(on page 160).
39