Device Management; Network Settings - Raritan dominion kx III Administrator's Manual

Chapter 4: KX III Administration

Device Management

90

Network Settings

Choose Failover or Isolation Mode
Configure KX III for Dual LAN Failover Mode
Configure KX III for Dual LAN Isolation Mode
Configure KX III for Dual LAN Failover Mode
LAN1 and LAN2 share the same IP address to support automatic
failover.
LAN1 is the primary port. If LAN1 fails, LAN2 is used to access KX III.
1. Select Device Settings > Network to open the Device Network
Settings page.
2. Set the IP Auto Configuration to None in the IPv4 section.
3. Select the "Enable Automatic Failover" checkbox under LAN
Interface Settings to enable failover.
4. Manually specify the network parameters by entering the Default
Gateway.
5. Enter the IPv4 IP Address, if needed. The default IP address is
192.168.0.192.
6. Enter the IPv4 Subnet Mask. The default subnet mask is
255.255.255.0.
(on page 40)
(on page 42)