Raritan dominion kx III Administrator's Manual page 140

Chapter 4: KX III Administration
128
3. On the Port Configuration page, click on the name of the blade
chassis you want to configure. The Port page will open.
4. Select the Blade Chassis radio button. The page will then display the
necessary fields to configure a blade chassis.
5. Select the IBM ® blade chassis model from the Blade Server Chassis
Model drop-down.
To configure a IBM BladeCenter H and E:
1. If you selected IBM BladeCenter
Configure the blade chassis as applicable. Prior to configuring a
blade chassis that can be auto-discovered, it must be configured to
enable SSH connections on the designated port number (see
Services (on page 147)). Additionally, a user account with the
corresponding authentication credentials must be previously created
on the blade chassis. The KX III only supports auto-discovery for
AMM[1].
a. Switch Hot Key Sequence - Predefined.
b. Maximum Number of Slots - The default maximum number of
slots available on the blade chassis is automatically entered.
c. Administrative Module Primary IP Address/Host Name - Enter
the primary IP address for the blade chassis. Required for
auto-discovery mode
d. Port Number - The default port number for the blade chassis is
22. Change the port number if applicable. Required for
auto-discovery mode
e. Username - Enter the username used to access the blade
chassis. Required for auto-discovery mode
f. Password - Enter the password used to access the blade
chassis. Required for auto-discovery mode
2. If you want the KX III to auto-discover the chassis blades, select the
Blade Auto-Discovery checkbox and then click Discover Blades on
Chassis Now. Once the blades are discovered, they will be displayed
on the page.
3. Change the blade chassis name if needed. If the chassis is already
named, that information automatically populates this field. If it is not
already named, the KX III assigns the chassis a name. The default
naming convention for the blade chassis by the KX III is
Blade_Chassis_Port#.
4. If operating in Manual mode, indicate the blades that are installed in
the blade chassis by checking the Installed checkbox next to each
slot that has a blade installed. Alternatively, use the Select All
checkbox. If needed, change the blade server names
If operating in Auto-discovery mode, the Installed box will display the
slots containing blades during discovery.
®
H or E, auto-discovery is available.
Device