Raritan dominion kx III Administrator's Manual page 160

Chapter 4: KX III Administration
148
3. Enter the SSH Port information. The standard SSH TCP port number
is 22 but the port number can be changed to provide a higher level of
security operations.
4. Click OK.
HTTP and HTTPS Port Settings
You are able to configure HTTP and/or HTTPS ports used by the KX III.
For example, if you are using the default HTTP port 80 for another
purpose, changing the port will ensure the device does not attempt to
use it.
1. Choose Device Settings > Device Services. The Device Service
Settings page opens.
2. Enter the new ports in the HTTP Port and/or HTTPS Port fields.
3. Click OK.
Entering the Discovery Port
KX III discovery occurs over a single, configurable TCP Port.
The default is Port 5000, but you can configure it to use any TCP port
except 80 and 443.
To access KX III from beyond a firewall, your firewall settings must
enable two-way communication through the default Port 5000 or a
non-default port configured on this page.
via Remote Console or command line interface (CLI).
To enable the discovery port:
1. Choose Device Settings > Device Services. The Device Service
Settings page opens.
2. Enter the Discovery Port.
3. Click OK.