Raritan dominion kx III Administrator's Manual page 126

Chapter 4: KX III Administration
114
4. Click OK. That rack PDU/outlet association is removed and a
confirmation message is displayed.
To remove a rack PDU association if the rack PDU has been
removed from the target:
1. Click Device Settings > Port Configuration and then click on the
active target.
2. Associate the active target to the disconnected power port. This will
break the disconnected target's power association.
3. Finally, associate the active target to the correct power port.
Configuring Blade Chassis
In addition to standard servers and rack PDUs (power strips), you can
control blade chassis that are plugged into the KX III port. Up to eight
blade chassis can be managed at a given time.
If the blade chassis type is supported, it is automatically detected once it
is connected.
When a blade chassis is detected, a default name is assigned to it and it
is displayed on the Port Access page along with standard target servers
and rack PDUs.
If the type is not supported, the blade must be configured manually. The
blade chassis must be configured as a blade chassis subtype.
For more information on how blades are displayed, see
Page (Remote Console Display)
Generic Blade Chassis Configuration
The Generic Blade Chassis' selection provides only a manual
configuration mode of operation.
See Supported Blade Chassis Models
CIMs for Blade Chassis
Recommended Blade Chassis Configurations
important, additional information when configuring the blade chassis.
See Dell Chassis Cable Lengths and Video Resolutions
385) for information on cable lengths and video resolutions when using
®
Dell chassis with the KX III.
To configure a generic blade chassis:
1. Connect the blade chassis to the KX III.
2. Select Device Settings > Port Configuration to open the Port
Configuration page.
(on page 21).
(on page 135),
(on page 135), and Required and
Port Access
Supported
(on page 138) for
(on page