Raritan dominion kx III Administrator's Manual page 138

Chapter 4: KX III Administration
126
10. Select the CIMs native, display resolution from the Display Native
Resolution drop-down. This is the preferred resolution and timing
mode of the digital CIM. Once a resolution is selected, it is applied to
the CIM.
If no selection is made, the default 1024x1280@60Hz resolution is
used.
11. Click OK to save the configuration.
To configure a Dell PowerEdge 1855/1955:
1. If you selected Dell 1855/1955, auto-discovery is not available.
Configure the blade chassis as applicable.
a. Switch Hot Key Sequence - Select the hot key sequence that will
be used to switch from KVM to the blade server. For Dell
1855/1955 models, KX III blocks all existing hot key sequences.
If you apply a Generic configuration to the Dell 1855, only one
existing hot key is blocked.
b. Maximum Number of Slots - The default maximum number of
slots available on the blade chassis is automatically entered.
c. Administrative Module Primary IP Address/Host Name - Not
applicable.
d. Port Number - The default port number for the blade chassis is
22. Not applicable.
e. Username - Not applicable.
f. Password - Not applicable.
2. Change the blade chassis name if needed.
3. Indicate the blades that are installed in the blade chassis by
checking the Installed checkbox next to each slot that has a blade
installed. Alternatively, use the Select All checkbox. If needed,
change the blade server names.
4. In the Blade Chassis Managed Links section of the page, you are
able to configure the connection to a blade chassis web browser
interface if one is available.
Click the Blade Chassis Managed Links icon to expand the section
on the page.
The first URL link is intended for use to connect to the blade chassis
Administration Module GUI.
Note: Access to the URL links entered in this section of the page is
governed by the blade chassis port permissions.