Changing A Usb Profile When Using A Smart Card Reader; Video Mode And Resolution Notes - Raritan dominion kx III Administrator's Manual

Video Mode and Resolution Notes

Changing a USB Profile when Using a Smart Card Reader

There may be certain circumstances under which you will need to
change the USB profile for a target server. For example, you may need
to change the connection speed to "Use Full Speed for Virtual Media
CIM" when the target has problems with the "High Speed USB"
connection speed.
When a profile is changed, you may receive a New Hardware Detected
message and be required to log in to the target with administrative
privileges to reinstall the USB driver. This is only likely to occur the first
few times the target sees the new settings for the USB device. Afterward,
the target will select the driver correctly.
Video Image Appears Dark when Using a Mac
®
If you are using a Mac
dark, enable DVI Compatibility Mode on the CIM to help resolve the
issue.
See Configuring CIM Ports
Video Shrinks after Adjusting Target Clock
® ®
On HP Proliant DL380p G8 target servers, certain resolutions cause
the target video to shrink. This is caused when the server's clock
attempts to auto-adjust and detects the wrong active line length.
Depending on the resolution the target is set to, this occurs when
connecting to the HP target from the KX III Remote Console or Local
Port, or both the Remote Console and Local Port. This issue was
detected at the following resolutions:
Target resolution Issue seen on
Local Port
1440x900@60Hz Yes
1400x1050@60Hz No
1152x864@60Hz No
with an HDMI video port and the video seems too
(on page 106)
Issue seen from
Remote Console
Yes
Yes
Yes
Appendix E: Informational Notes
409