Raritan dominion kx III Administrator's Manual page 152

Chapter 4: KX III Administration
Blade chassis
® ®
IBM /Dell
Auto-Discovery
IBM KX3 Virtual
Media
®
Cisco UCS
Server Chassis
140
Required/recommended action
 It is recommended that Auto-Discovery be enabled when
applying blade level access permissions. Otherwise, set access
permissions on a blade-chassis wide basis.
 Secure Shell (SSH) must be enabled on the blade chassis
management module.
 The SSH port configured on the blade chassis management
module and the port number entered on the Port Configuration
page must match.
 Raritan KX III virtual media is supported only on IBM
®
BladeCenter Models H and E. This requires the use of the
D2CIM-DVUSB. The black D2CIM-DVUSB Low-Speed USB
connector is attached to the Administrative Management Module
(AMM) at the rear of the appliance. The gray D2CIM-DVUSB
High-Speed USB connector is attached to the Media Tray (MT)
at the front of the appliance. This will require a USB extension
cable.
 The Cisco KVM cable (N20-BKVM) enables you to perform
server blade administration, configuration, and diagnostic
procedures by connecting video and USB devices directly to the
server blade.
 Source: Cisco UCS 5108 Server Chassis Installation Guide-
DCIM-USBG2, D2CIM-VUSB, D2CIM-DVUSB
Note: All IBM BladeCenters that use AMM must use AMM firmware
version BPET36K or later to work with the KX III.
Note: In the case of IBM Blade Center Models E and H, the KX III only
supports auto-discovery for AMM[1] as the acting primary management
module.
Blade Chassis Sample URL Formats
This table contains sample URL formats for blade chassis being
configured in the KX III.
Blade chassis
®
Dell M1000e
Dell 1855
Sample URL format

URL: https://192.168.60.44/cgi-bin/webcgi/login

Username: root

Username Field: user

Password: calvin

Password Field: password

URL: https://192.168.60.33/Forms/f_login

Username: root

Username Field: TEXT_USER_NAME