Raritan dominion kx III Administrator's Manual page 186

Chapter 4: KX III Administration
174
Use the reset to factory defaults feature to remove the SNMP
configuration and set the KX III to its original factory default.
To reset to factory defaults:

Click Reset To Defaults.
WARNING: When using SNMP traps over UDP, it is possible for the
KX III and the router that it is attached to fall out of synchronization
when the KX III is rebooted, preventing the reboot completed SNMP
trap from being logged.
List of KX III SNMP Traps
SNMP provides the ability to send traps, or notifications, to advise an
administrator when one or more conditions have been met.
The following table lists the KX III SNMP traps:
Trap Name
bladeChassisCommError
cimConnected
cimDisconnected
cimUpdateStarted
cimUpdateCompleted
configBackup
configRestore
deviceUpdateFailed
deviceUpgradeCompleted
deviceUpgradeStarted
factoryReset
firmwareFileDiscarded
firmwareUpdateFailed
firmwareValidationFailed
groupAdded
groupDeleted
groupModified
ipConflictDetected
Description
A communications error with blade chassis
device connected to this port was detected.
The CIM is connected.
The CIM is disconnected.
The CIM update start is underway.
The CIM update is complete.
The device configuration has been backed up.
The device configuration has been restored.
Device update has failed.
The KX III has completed update via an RFP file.
The KX III has begun update via an RFP file.
The device has been reset to factory defaults.
Firmware file was discarded.
Firmware update failed.
Firmware validation failed.
A group has been added to the KX III system.
A group has been deleted from the system.
A group has been modified.
An IP Address conflict was detected.