Raritan dominion kx III Administrator's Manual page 258

Chapter 4: KX III Administration
246
Step 2: Connect the Target Server to the KX III
Dual port video groups can be created from existing port connections, or
new port connections.
The steps provided here assume you are creating new connections.
If you are creating a dual port video group from existing connections, see
Step 4: Create the Dual Video Port Group
To connect the equipment:
1. Install and power up your target server per the manufacturer's
instructions if you have not already done so.
2. Attach each CIM's video connector to each of the target's video
output ports, then connect the USB cables to available USB ports on
the target.
3. Connect each CIM to the Raritan device using a CAT5/6 cable.
4. If you have not already done so:
a. Connect the Raritan device to an AC power source using the
provided power cable
b. Connect to the Raritan device network port and local port (if
needed)
c. Configure the Raritan device.
5. Launch a supported web browser.
6. Enter the URL that corresponds to the client you want to use:

http://IP-ADDRESS launches the Active KVM Client from
supported Microsoft .Net based environments or launches the
Virtual KVM Client
Or

http://IP-ADDRESS/vkc for the Java-based Virtual KVM Client
Or

http://IP-ADDRESS/vkcs for the standalone Java-based Virtual
KVM Client for Chrome browsers
Or

http://IP-ADDRESS/admin for an administration-only client
without target access capability. This client does not
require .NET or Java.
IP-ADDRESS is the IP address assigned to your KX III
You can also use HTTPS, or the DNS name of the KX III assigned by
your administrator (if applicable).
You are always redirected to the IP address from HTTP to HTTPS.
(on page 247).