Raritan dominion kx III Administrator's Manual page 50

Chapter 4: KX III Administration
38
B. Network Ports
Two network ports are provided to allow for both failover and isolation
modes.
Connect a standard Ethernet cable from the LAN1 network port on the
KX III to an Ethernet switch, hub, or router.
If you will use failover or isolation modes, connect a standard Ethernet
cable from the LAN2 network port on the KX III to an Ethernet switch,
hub, or router.
See Choose Failover or Isolation Mode
C: Local User Port (Local Console)
To connect the keyboard and mouse:

Connect a USB keyboard and mouse to the respective Local User
port on the back of KX III.
Use the KX III Local User port for administrative and target device
access at the rack. The Local User port is required for installation and
setup, but is optional for subsequent use.
D. Local DVI-D Port
A single link DVI cable is used to connect to a local DVI monitor or
keyboard tray (not included with the KX III).
Connect to the DVI port on Raritan's T1700-LED or T1900-LED keyboard
tray.
Use a required DVI-D to VGA converter to connect to VGA monitors.
Connect to a DVI Monitor
The local monitor must support a minimum 1024x768 resolution.
1. Connect a USB keyboard and mouse to the respective Local User
ports on the back of KX III.
2. Connect a DVI cable from the DVI-D port on the back of KX III to the
DVI monitor.
Connect to a VGA Monitor (Optional)
To connect to a VGA monitor:
1. Connect a USB keyboard and mouse to the respective Local User
ports on the back of the KX III.
(on page 40) for more details.