Dual Video Port Groups - Raritan dominion kx III Administrator's Manual

Chapter 4: KX III Administration

Dual Video Port Groups

240
Name Command
The name command is used to configure the Device Name and preferred
hostname. The syntax of the name is:
name [devicename <devicename>] [hostname <hostname>]
Device name configuration
devicename <devicename>
hostname <hostname>
only)
Name Command Example
The following command sets the device name:
Admin > Config > Network > name devicename My-KSX2
IPv6 Command
Use the IPv6_interface command to set IPv6 network parameters and
retrieve existing IPv6 parameters.
Ipv6_interface mode enable ipauto none ip
2001:db8:290c:1291::17 prefixlen 128 gw
2001:db8:290c:1291::1
Servers with dual video cards can be remotely accessed with an
extended desktop configuration, which is available to remote users. This
is done by creating dual port video groups.
Extended desktop configurations allow you to view the target server
desktop across two monitors vs. the standard single monitor view.
Once a dual port video group is selected, all port channels in that group
open simultaneously.
See Dual Port Video Configuration Steps
Review the information in this section for important information regarding
dual port video groups.
Note: Dual port video groups are not supported by models with only one
KVM channel such as KX3-108 and KX3-116 models.
Device Name
Preferred host name (DHCP
(on page 245)