Raritan dominion kx III Administrator's Manual page 226

Chapter 4: KX III Administration
214
Restore Your KX III Using a Restore File
WARNING: Exercise caution when restoring your KX III to an earlier
version. Usernames and password in place at the time of the backup
will be restored. If you do not remember the old administrative
usernames and passwords, you will be locked out of the KX III.
In addition, if you used a different IP address at the time of the
backup, that IP address will be restored as well. If the configuration
uses DHCP, you may want to perform this operation only when you
have access to the local port to check the IP address after the update.
Follow the steps here to apply a KX II backup/restore file to apply
settings from the KX II to the KX III. Before proceeding, review the
information in Requirements to Apply a KX II Backup and Restore
File to a KX III (on page 215).
Note that some settings cannot be applied from a KX II to a KX III using
the backup/restore function. See
Backup/Restore File Settings and Functions
To restore your KX III:
1. Choose Maintenance > Backup/Restore. The Backup/Restore page
opens.
2. Choose the type of restore you want to run:

Full Restore - A complete restore of the entire system. Generally
used for traditional backup and restore purposes.

Protected Restore - Everything is restored except
appliance-specific information such as IP address, name, and so
forth. With this option, you can setup one KX III and copy the
configuration to multiple KX III appliances.

Custom Restore - With this option, you can select User and
Group Restore, Device Settings Restore, or both:
KX II-to-KX III Unsupported
(on page 216)