Raritan dominion kx III Administrator's Manual page 150

Chapter 4: KX III Administration
Blade chassis
IBM BladeCenter HT The BladeCenter HT chassis ships standard
This table contains information on limitations and constraints that apply to configuring
blade chassis to work with the KX III. Raritan recommends that all of the information
below is followed.
Blade chassis
®
Dell
PowerEdge ™
M1000e
138
Connection method
the Management Module only features the
LEDs for displaying status. All Ethernet and
KVM connections are fed through to the rear to
the LAN and KVM modules.
The KVM module is a hot swap module at the
rear of the chassis providing two PS/2
connectors for keyboard and mouse, a
systems-status panel, and a HD-15 video
connector.
Source: IBM BladeCenter Products and
Technology
with one Advanced Management Module. This
module provides the ability to manage the
chassis as well as providing the local KVM
function.
Source: IBM BladeCenter Products and
Technology
Note: In order to support Auto-discovery, IBM BladeCenter Models H and
E must use AMM with firmware version BPET36K or later.
Note: In the case of IBM Blade Center Models E and H, the KX III only
supports auto-discovery for AMM[1] as the acting primary management
module.
Note: Audio is disabled for all KVM switch targets.
Required and Recommended Blade Chassis Configurations
Required/recommended action
 Disable the iKVM GUI screensaver. An authorize dialog will
appear, preventing iKVM from working correctly, if this is not
done.
 Exit the iKVM GUI menu before attaching Dell's chassis to a
Raritan CIM. iKVM may not work correctly if this is not done.
 Configure the iKVM GUI Main menu to select target blades by
Slot, not by Name. iKVM may not work correctly if this is not
Recommended CIM(s)

DCIM-USBG2