Raritan dominion kx III Administrator's Manual page 52

Chapter 4: KX III Administration
40
3. Enter the old password raritan, then enter and reenter a new
password.
4. Passwords can be up to 64 characters in length consisting of English
alphanumeric characters and special characters.
5. Click Apply.
6. Click OK on the Confirmation page.
Assign the KX III a Device Name
Open the Device Network Settings page in the KX III Remote client
1. Specify a meaningful Device Name for your KX III device.
Up to 32 alphanumeric and valid special characters, no spaces
between characters.
Next, configure the IP address and DNS settings.
Choose Failover or Isolation Mode
Configure KX III for Dual LAN Failover Mode
Configure KX III for Dual LAN Isolation Mode
Configure KX III for Dual LAN Failover Mode
LAN1 and LAN2 share the same IP address to support automatic
failover.
LAN1 is the primary port. If LAN1 fails, LAN2 is used to access KX III.
1. Select Device Settings > Network to open the Device Network
Settings page.
2. Set the IP Auto Configuration to None in the IPv4 section.
3. Select the "Enable Automatic Failover" checkbox under LAN
Interface Settings to enable failover.
4. Manually specify the network parameters by entering the Default
Gateway.
(on page 40)
(on page 42)