Raritan dominion kx III Administrator's Manual page 142

Chapter 4: KX III Administration
130
6. If applicable, define the USB profile for the blade chassis or select an
existing USB profile. Click the USB Profiles Select USB Profiles for
Port icon
to Other Ports icon
expand these sections of the page. See
(Port Page) (on page 141).
7. Click OK to save the configuration.
To configure a IBM BladeCenter (Other):
1. If you selected IBM BladeCenter (Other), auto-discovery is not
available. Configure the blade chassis as applicable.
a. Switch Hot Key Sequence - Select the hot key sequence that will
be used to switch from KVM to the blade server.
b. Administrative Module Primary IP Address/Host Name - Enter
the primary IP address for the blade chassis. Not applicable.
c. Maximum Number of Slots - Enter the default maximum number
of slots available on the blade chassis.
d. Port Number - The default port number for the blade chassis is
22. Not applicable.
e. Username - Not applicable.
f. Password - Not applicable.
2. Change the blade chassis name if needed.
3. Indicate the blades that are installed in the blade chassis by
checking the Installed checkbox next to each slot that has a blade
installed. Alternatively, use the Select All checkbox. If needed,
change the blade server names. If it is not already named, the KX III
assigns a name to the blade server. The default blade server naming
convention is Blade_Chassis_Port#_Slot#.
4. In the Blade Chassis Managed Links section of the page, you are
able to configure the connection to a blade chassis web browser
interface if one is available.
Click the Blade Chassis Managed Links icon to expand the section
on the page.
The first URL link is intended for use to connect to the blade chassis
Administration Module GUI.
Note: Access to the URL links entered in this section of the page is
governed by the blade chassis port permissions.
or the Apply Select Profiles
to
Configuring USB Profiles