Raritan dominion kx III Administrator's Manual page 110

Chapter 4: KX III Administration
1 For each LAN, choose the LAN Interface Speed & Duplex from the following
options:
 Autodetect (default option)
 10 Mbps/Half - Both KX III device LEDs blink
 10 Mbps/Full - Both KX III device LEDs blink
 100 Mbps/Half - Yellow KX III device LED blinks
 100 Mbps/Full - Yellow KX III device LED blinks
 1000 Mbps/Full (gigabit) - Green KX III device LED blinks
 Half-duplex provides for communication in both directions, but only one
direction at a time (not simultaneously).
 Full-duplex allows communication in both directions simultaneously.
Note: Occasionally there are problems running at 10 Mbps in either half or full
duplex. If you are experiencing problems, try another speed and duplex setting.
See Network Speed Settings
Click OK to apply the setting.
2 Selecting the Enable Automatic Failover checkbox allows the KX III to
automatically recover its network connection.
To do this, it uses the second network port if the active network port fails.
See Configure KX III for Dual LAN Failover Mode
Note: Because a failover port is not activated until after a failover has actually
occurred, Raritan recommends that you do not monitor the port or only monitor the
port after a failover occurs.
Click OK to apply the setting.
98
(on page 384) for more information.
(on page 40).