Scanning Ports Slide Show - Remote Console - Raritan dominion kx III Administrator's Manual

Chapter 10: KX III Remote Console

Scanning Ports Slide Show - Remote Console

When you start a scan, the Port Scan window opens.
As each target is found, it is displayed as a thumbnail in a slide show.
The slide show scrolls through the target thumbnails based on the
default interval of 10 seconds or according to the interval you specify.
As the scan scrolls through the targets, the target that is the focus of the
slide show displays in the center of the page.
The name of the target is displayed below its thumbnail and in the task
bar at the bottom of the window.
If a target is busy, a blank screen is displayed instead of the target server
access page.
Configure scan settings for the Remote Console from VKC, VKCS, or
AKC.
See Configuring Port Scan Settings in VKC/VKCS and AKC (on page
297)
Note: Scan port settings for the Local Console are configured on the
Local Port Settings page. See Scanning Ports - Local Console (on
page 345)
331