Raritan dominion kx III Administrator's Manual page 104

Chapter 4: KX III Administration
92

Link-Local IP Address - this address is automatically assigned to
the device. It is used for neighbor discovery or when no routers
are present.

Zone ID - Identifies the device the address is associated with.
Read-Only
10. Next, select "Use the Following DNS Server Addresses" and enter
the Primary DNS Server IP Address and Secondary DNS Server IP
Address. The secondary address is used if the primary DNS server
connection is lost due to an outage.
Note: "Obtain DNS Server Address Automatically" and "Preferred
DHCP Host Name" are only enabled when KX III is configured in
DHCP mode
11. When finished, click OK. Your KX III device is now network
accessible.
Configure KX III for Dual LAN Isolation Mode
Isolation mode allows you to access each LAN port independently using
different IP addresses.
Failover is not supported in this mode.
1. Select Device Settings > Network to open the Device Network
Settings page.
2. Set the IP Auto Configuration to None in the IPv4 section.