Target Server Video Resolutions; Step 1: Configuring Network Firewall Settings; Step 3: Connecting The Equipment; B: Network Ports - Raritan Dominion KX III Quick Setup Manual

4. Mount the entire assembly in your rack and secure the
side brackets' ears to the rack's front rails with your own
screws, bolts, cage nuts, and so on.
5. When connecting cables to the rear panel of the user
station or switch, drape them over the cable-support bar.
QS Rule

Step 1: Configuring Network Firewall Settings

TCP Port 5000
Enable remote access to KX III by allowing network and
firewall communication on TCP Port 5000.
Alternatively, configure KX III to use a different TCP port, and
allow that port network and firewall communication.
TCP Port 443
Allow access to TCP Port 443 (Standard HTTPS) so you can
access KX III via a web browser.
TCP Port 80
Allow access to TCP Port 80 (Standard HTTP) to enable
automatic redirection of HTTP requests to HTTPS.
QS Rule
Step 2: Configuring KVM Target Servers
Mouse Settings
Raritan recommends using Absolute Mouse Synchronization
to minimize mouse settings on target servers. For additional
information, see Additional Supported Mouse Settings
(http://www.raritan.com/help/kx-iii/v3.0.0/en/index.htm#3
3105) Additional Supported Mouse Settings in Online Help.
In this mode, absolute coordinates are used to keep the client
and target cursors in synch, even when the target mouse is
set to a different acceleration or speed.
This mode is supported on servers with USB ports and is the
default mode for virtual media CIMs.
Absolute Mouse Synchronization requires the use of a virtual
media CIM -
D2CIM-VUSB
•
D2CIM-DVUSB
•
Dominion KX III Quick Setup Guide
QSG-DKX3-v3.5.0-0J-E  255-62-0003-00-RoHS
D2CIM-DVUSB-DVI
•
D2CIM-DVUSB-HDMI
•
D2CIM-DVUSB-DP
•

Target Server Video Resolutions

For a list of supported target video server resolutions, see KX
III Supported Target Server Video Resolutions in Online
Help.
QS Rule

Step 3: Connecting the Equipment

A: AC Power
1. Use the power cords that came with KX III. Use both cords
with AC power outlets for dual-power failover protection.
Optional For details on enabling power supply autodetection
from the Remote Console, see Specify Power Supply
Autodetection in online help.

B: Network Ports

Connect a standard Ethernet cable from the LAN1 network
port to an Ethernet switch, hub, or router.
To enable the failover or isolation mode capabilities, connect
a standard Ethernet cable from the LAN2 network port to an
Ethernet switch, hub, or router.
2