HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 830

Fabric OS Commands
Example
Notice that in the following example, the only parameter modified is the number
of MissingSFPS allowed before a MARGINAL status is triggered:
switch:admin> switchStatusPolicySet
To change the overall switch status policy parameters
The current overall switch status policy parameters:
----------------------------------
FaultyPorts
MissingSFPs
PowerSupplies
Temperatures
PortStatus
ISLStatus
Note that the value, 0, for a parameter, means that it is
NOT used in the calculation.
** In addition, if the range of settable values in the prompt is (0..0),
** the policy parameter is NOT applicable to the switch.
** Simply hit the Return key.
The minimum number of
FaultyPorts contributing to DOWN status: (0..64) [2]
FaultyPorts contributing to MARGINAL status: (0..64) [1]
MissingSFPs contributing to DOWN status: (0..64) [0]
MissingSFPs contributing to MARGINAL status: (0..64) [0] 1
Bad PowerSupplies contributing to DOWN status: (0..4) [2]
Bad PowerSupplies contributing to MARGINAL status: (0..4) [1]
Bad Temperatures contributing to DOWN status: (0..8) [2]
Bad Temperatures contributing to MARGINAL status: (0..8) [1]
Bad Fans contributing to DOWN status: (0..3) [2]
Bad Fans contributing to MARGINAL status: (0..3) [1]
Down PortStatus contributing to DOWN status: (0..64) [0]
Down PortStatus contributing to MARGINAL status: (0..64) [0]
Down ISLStatus contributing to DOWN status: (0..64) [2]
Down ISLStatus contributing to MARGINAL status: (0..64) [1]
Policy parameter set has been changed
switch:admin>
See Also
switchStatusPolicyShow
switchStatusShow
830
Down Marginal
1 0
0 1
2 1
2 1
Fans 2 1
0 0
2 1
Fabric OS Version 3.1.x/4.1.x Reference Guide