HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 548

Fabric OS Commands
Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
lockmode
privatemode
Example
To configure switch blade 2 port 3 as a locked L_PORT:
switch:admin> portCfgLport 2/3, 1
done.
See Also
configure
portShow
switchShow
548
Specify the slot number for a StorageWorks Core switch.
For all other switches this operand is not required. The slot
number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot
number (1 through 4, or 7 through 10), and port number
(0 through 15).
The StorageWorks Core switch has a total of 1–10 slots.
Slot number 5 and 6 are control processor cards, and slot
1 through 4, and 7 through 10, are port cards. On each
port card, there are 16 ports counted from the bottom, 0 to
15.
Specify a port number. Valid values for port number vary
depending on the switch type. This operand is required.
Specify 1 to configure the specified port as a locked
L_PORT. Specify 0 to de-configure the specified port from
its previous role as a locked L_PORT. This operand is
required.
Specify 1 to configure the L_PORT as a private L_PORT
(then FLOGI will be rejected). Specify 0 to configure the
L_PORT as a normal public L_PORT. The default value is 0.
This operand is optional.
Fabric OS Version 3.1.x/4.1.x Reference Guide