HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 511

Note:
Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
TxSIDMsk
TxDIDMsk
RxSIDMsk
RxDIDMsk
Fabric OS Version 3.1.x/4.1.x Reference Guide
This command requires an Advanced Performance Monitoring license.
Specify the slot number for a StorageWorks Core switch. For
all other switches this operand is not required. The slot
number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot number
(1 through 4, or 7 through 10), and port number (0 through
15).
The StorageWorks Core switch has a total of 1–10 slots. Slot
number 5 and 6 are control processor cards, and slot 1
through 4, and 7 through 10, are port cards. On each port
card, there are 16 ports counted from the bottom, 0 to 15.
Specify a port number. Valid values for port number vary
depending on the switch type. This operand is required.
Specify the source ID mask in "dd:aa:pp" format, where "dd"
is Domain ID mask, "aa" is Area ID mask and "pp" is AL_PA
ID mask. For example, "00:ff:00" uses TxSID Area ID to
trigger EE monitor comparison.
Specify the following values to turn on or off a specific field:
00 - Specifies that the field does not trigger EE monitors.
ff - This specifies that the field triggers EE monitors.
This operand must be enclosed in quotation marks. This
operand is required.
Specify the destination ID mask in "dd:aa:pp" format. This
operand must be enclosed in quotation marks. This operand
is required.
Specify the source ID mask in "dd:aa:pp" format. This
operand must be enclosed in quotation marks. This operand
is required.
Specify the destination ID mask in "dd:aa:pp" format. This
operand must be enclosed in quotation marks. This operand
is required.
perfSetPortEEMask
511