Secpolicycreate - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

secpolicycreate

Create a new policy.
Synopsis
secpolicycreate name[, "member;member"]
Availability
Admin
Release
V3.1.x and V4.1.x
Description
Use this command to create a new policy. All policies can be created only once,
except for the DCC_POLICY_nnn. Each DCC_POLICY_nnn must each have a
unique name.
Adding members while creating a policy is optional. You may add members to a
policy later, using the secpolicyadd command.
Each policy corresponds to a management method. The list of members of a
policy acts as an access control list for that management method. When security is
first enabled using the secmodeenable command only the FCS_POLICY
exists. Before a policy is created, there is no enforcement for that management
method, that is, all access is granted. After a policy has been created and a
member has been added to the policy, that policy becomes closed to all access
except from included members. If all members are then deleted from the policy,
all access is denied for that management access method.
Note:
secmodeenable command.
When security is enabled, this command can only be issued from the Primary FCS
switch. See
If a TELNET_POLICY or SERIAL_POLICY is created that will end the current sectelnet or
serial session, a warning is issued.
Fabric OS Version 3.1.x/4.1.x Reference Guide
The FCS_POLICY can only be created when enabling security mode using the
"Security Commands" on page 941.
secpolicycreate
707