HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 797

55. diagshow (V4.1.x only)
56. portshow (V4.1.x only)
57. portregshow (V4.1.x only)
58. portrouteshow (V4.1.x only)
Operands
This command has the following operands:
firstPort
(V3.1.x only)
lastPort
(V3.1.x only)
nLog
(V3.1.x only)
slotnumber
(V4.1.x only)
Fabric OS Version 3.1.x/4.1.x Reference Guide
Displays diagnostic information for the slot specified, if no slot is specified
then all slots on logical switch are displayed.
Displays port information for all ports specified. The default value is to
display information for all ports.
Specify the first port of a range of ports to dump information.
The default (if no operand specified) is to print state of port 0. If
only firstPort is specified, only information for
firstPort is printed. This operand is optional.
Specify the last port of range of ports to dump information. If
firstPort is specified, but lastPort is not specified,
only firstPort information is printed for the port based
commands (portShow, portRegShow, portRouteShow).
If no operand is supplied, firstPort is set to 0 and
lastPort is set to maximum port of switch. This operand is
optional.
Specify the number of lines of PortLogDump to print:
This operand is optional.
Specify the slot number for a StorageWorks Core switch. For all
other switches this operand is not required. The slot number
must be followed by a slash ( / ) and the port number, so that
each port is represented by both slot number (1 through 4, or 7
through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10 slots. Slot
number 5 and 6 are control processor cards, and slot 1
through 4, and 7 through 10, are port cards. On each port
card, there are 16 ports counted from the bottom, 0 to 15.
0 = dump all lines (default)
N = dump the last N lines
<0 = skip portLogDump output
supportShow
797