HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 374

Fabric OS Commands
Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
When no slot number and port number are specified, this command displays the
interface information for all ports on the switch (including non E_Ports).
Examples
To display FSPF interface information:
switch:admin> interfaceShow 4/0
idbP = 0x10f61f40
Interface 4 data structure:
nghbP = 0x10f61d90
ifNo = 4
cost = 1000
delay = 1
lastScn = 5
lastScnTime = Mar 29 12:57:52.833
upCount = 2
lastUpTime = Mar 29 12:57:52.833
downCount = 1
lastDownTime = Mar 29 12:57:47.566
downReason = 2
iState = UP
Type <CR> to continue, Q<CR> to stop:
< sample output truncated >
374
Specify the slot number for a StorageWorks Core switch.
For all other switches this operand is not required. The slot
number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot
number (1 through 4 or 7 through 10) and port number (0
through 15).
The StorageWorks Core switch has a total of 1–10 slots.
Slot number 5 and 6 are control processor cards, and slot
1 through 4, and 7 through 10, are port cards. On each
port card, there are 16 ports counted from the bottom, 0 to
15.
Specify a port number. Valid values for port number vary
depending on the switch type. This operand is optional.
Fabric OS Version 3.1.x/4.1.x Reference Guide