HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 382

Fabric OS Commands
Fibre Channel
Subnetmask
Gateway Address
Parameters: V4.1.x
For a StorageWorks Core switch, you must set values for both logical switches
and both CP cards. Use the option operand to select the logical switch or CP
where you want to configure an IP address. The option operand is only
available for the StorageWorks Core switch. If the option operand is not
specified for a StorageWorks Core switch, the command becomes interactive.
Each Logical switch has:
Each CP has:
The default values for hostname, ipaddress, subnet address (for CP only), mask
(for switch only), and gateway address (for CPs only) are:
Entering Values and Saving Changes
After each prompt the current value is shown. You may:
382
Ethernet IP Address
Ethernet Subnetmask
Fibre Channel IP Address
Fibre Channel Subnetmask
Ethernet IP Address
Ethernet Subnetmask
Host Name
Gateway IP Address
sw0 = hostname SW12000_1, ip 10.77.77.77, mask 255.0.0.0
sw1 = hostname SW12000_2, ip 10.77.77.76, mask 255.0.0.0
cp0 = hostname cp0, ip 10.77.77.75, subnet 255.0.0.0, gateway 0.0.0.0
cp1 = hostname cp1, ip 10.77.77.74, subnet 255.0.0.0, gateway 0.0.0.0
Press Enter to retain the current value
Enter an IP address in conventional dot notation
Enter none
Set the Fibre Channel subnetmask of the switch.
Set the gateway IP address for the switch.
Fabric OS Version 3.1.x/4.1.x Reference Guide