HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 283

Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
Example
To display the fcp rls information (V4.1.x example):
switch:admin> fcprlsshow 9/1
link fail
switch:admin>
See Also
portloginshow
portshow
Fabric OS Version 3.1.x/4.1.x Reference Guide
Specify the slot number for a StorageWorks Core
switch. For all other switches this operand is not
required. The slot number must be followed by a slash
( / ) and the port number, so that each port is
represented by both slot number (1 through 4, or 7
through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10
slots. Slot number 5 and 6 are control processor cards,
and slot 1 through 4, and 7 through 10, are port
cards. On each port card, there are 16 ports counted
from the bottom, 0 to 15.
Specify a port number. Valid values for port number
vary depending on the switch type. This operand is
required.
loss sync loss sig prtc err bad word
fcprlsshow
crc err
283