Portcfgislmode - HP StorageWorks MSA 2/8 - SAN Switch Reference Manual

portcfgislmode

Enable or disable ISL R_RDY Mode on a port.
Synopsis: V3.1.x
portcfgislmode portnumber, [1 | 0]
Synopsis: V4.1.x
portcfgislmode [slotnumber/]portnumber, [1 | 0]
Availability
Admin
Release
V3.1.x and V4.1.x
Description
Use this command to enable or disable ISL R_RDY Mode on a port. If enabling
ISL R_RDY Mode on a port make sure the PID format is consistent across the
entire fabric. Refer to the configure command for more information on the
Core PID format.
Use the portcfgshow command to view the enabled modes on a port.
Operands
This command has the following operands:
slotnumber
(V4.1.x only)
Fabric OS Version 3.1.x/4.1.x Reference Guide
Specify the slot number for a StorageWorks Core
switch. For all other switches this operand is not
required. The slot number must be followed by a slash
( / ) and the port number, so that each port is
represented by both slot number (1 through 4, or 7
through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10
slots. Slot number 5 and 6 are control processor cards,
and slot 1 through 4, and 7 through 10, are port
cards. On each port card, there are 16 ports counted
from the bottom, 0 to 15.
portcfgislmode
539