HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 414

Fabric OS Commands
payload_pattern
(V3.1.x only)
pattern_width
(V3.1.x only)
--slot number
(V4.1.x only)
-nframes count
(V4.1.x only)
-ports itemlist
(V4.1.x only)
-seed
payload_pattern
(V4.1.x only)
-width
pattern_width
(V4.1.x only)
414
Specify the pattern of the test packets payload.
Specify the width of the pattern which user specified.
Valid values are:
1 = byte
2 = word
4 = quad
Specify the slot number in a StorageWorks Core switch.
The slot number must be followed by a slash ( / ) and
the port number.
The StorageWorks Core switch has a total of 10 slots
counted from 1 to 10. Slot number 5 and 6 are control
processor cards, and slot 1 through 4, and 7 through
10, are switch cards. On each switch card, there are 16
ports counted from the bottom, 0 to 15. A particular
port must be represented by both slot number
(1 through 4 or 7 through 10) and port number (0
through 15).
This operand is not required for switches that do not
have slots.
Specify the number of times (or number of frames per
port) to execute this test. The default value is 10.
Specify a list of user ports to test. By default all the user
ports in the current slot are tested. Refer to itemlist
for more information on selecting ports.
Specify the seed pattern of the test packets.
Specify the width of the test pattern. Valid values
include:
1 for byte
2 for word
3 for quad
This operand is optional.
Fabric OS Version 3.1.x/4.1.x Reference Guide